Measurements Parameters Optimisation for X-Ray Diffractometry Measurements of Stress State Around the Rivets

• Autorzy: Gadalińska E.

Identyfikatory

DOI

10.2478/v10164-010-0006-x

• Języki publikacji: EN

Abstrakty

EN

X-ray diffractometry is one of the basic methods of stress measurement. This method was used to measure stress distributions around rivets as described further in this paper. There were two types of riveted samples, six types of samples made of rivet wire (after different types of treatment) and a aluminium sheet sample with three measurement areas: plate with both cladding and anodized layer, plate after removing the anodized layer and plate after removing both cladding and anodized layer. Riveted samples were prepared to measure the stress distribution around the rivets and the samples of wire and the plate with three areas were prepared to check the effect of different types of treatment on stress state.

• Wydawca: Wydawnictwa Naukowe Sieci Badawczej Łukasiewicz - Instytutu Lotnictwa
• Czasopismo: Fatigue of Aircraft Structures
• Rocznik: 2009
• Tom: Iss. 1
• Strony: 58--62
• Opis fizyczny: Bibliogr. 8 poz., fot., rys., tab.

Twórcy

autor

Gadalińska E.

• Institute of Aviation, Warsaw, Poland

Bibliografia

• 1. Muller, R. P. G. (1995). An Experimental and Analytical Investigation on the Fatigue Behavior of Fuselage Riveted Lap Joints. Ph. D. Thesis, pp.161. Netherlands: Delft University of Technology.
• 2. Hakanen, M. (2007). Institute of Aviation - XRD measurements on riveted samples, Unpublished report. Vaajakoski, Finland: Stresstech Oy. (#699)
• 3. Hakanen, M. (2008). Institute of Aviation - Residual stress on rivets. Unpublished report. Vaajakoski, Finland: Stresstech Oy. (#744)
• 4. Cullity, B. D. (1964). Fundamentals of X-ray diffraction. Warsaw: PWN.
• 5. ASM Handbook. (2004). Metallography and Microstructures. Vol. 9. ASM International.
• 6. ASM Handbook. (1990). Properties and selection: Nonferrous Alloys and Special-Purpose Materials. Vol. 2. ASM International.
• 7. Industrial standard of Soviet Union. Mushroom head rivets with compensator. (OST 1 34040-79)
• 8. Internal standard of PZL Mielec. Countersunk rivet. (ANU 0301)