PL EN


Preferencje help
Widoczny [Schowaj] Abstrakt
Liczba wyników
Tytuł artykułu

Analysis of impact of aeration modifications on strength parameters of concrete under fire conditions

Treść / Zawartość
Identyfikatory
Warianty tytułu
Języki publikacji
EN
Abstrakty
EN
Modern dynamically developing building industry poses more and more complex challenges to building materials. Elevated constructions must satisfy a number of requirements including safety, durability and being environmentally friendly. The unfavorable impact of increased temperatures on the work of a construction structure is manifested by the change in the properties of the heated material and the occurrence of deformation, stresses and thermal scratches. These are particularly dangerous phenomena when they occur in elements with limited freedom of linear deformation. The purpose of the research presented in this article was to find a solution for concrete that is both resistant to spalling and characterized by high strength properties after heating. The main thesis put forward by the authors of the article is the assumption that deliberate concrete aeration will allow the introduction of evenly distributed micro air bubbles into its volume, which will constitute a reservoir for increasing the volume of water converting into water vapor as a result of a sudden increase in temperature. The presented schema enabled the assumption that the strength parameters of aerated concrete would decrease slightly in relation to non-aerated concrete, however it would be still possible to use in reinforced concrete constructions. As can be seen from the aforementioned analyzes, aeration modification can be an effective means of designing high temperature resistant concrete.
Słowa kluczowe
Twórcy
autor
  • Department Faculty of Fire Safety Engineering, Main School of Fire Service, Poland
autor
  • University of Natural Sciences and Humanities in Siedlce, Poland
Bibliografia
  • Abramowicz, M. and Adamski, R.A. (2002). Bezpieczenstwo pozarowe budynkow. Cz. 1. Warszawa: Szkola Glowna Sluzby Pozarniczej.
  • Abrams, M.S. (1973). Compressive strength of concrete at temperatures to 1,600F. Skokie, Ill.: Portland Cement Association.
  • Bažant, Z.P. and Kaplan, M.F. (1996). Concrete at high temperatures. Material properties and mathematical models. Harlow, Essex: Longman.
  • Bednarek, Z. and Krodkiewski, R. (1987). Wytrzymalosc materialow z przykladami. Zagadnienia cieplne. Warszawa: SGSP.
  • Dabrowski, K., Stachurski, W. and Zielinski, J.L. (1982). Konstrukcje betonowe. 2nd rev. ed. Warszawa: Arkady.
  • Grabiec, K. (1987). Wplyw temperatur pozarowych na bezpieczenstwo konstrukcji budowlanych. Przeglad Budowlany, no. 10, pp. 37-41.
  • Halicka, A., Ogrodnik, P. and Zegardlo, B. (2013). Using ceramic sanitary ware waste as concrete aggregate. Construction and Building Materials, vol. 48, pp. 295-305.
  • Kosiorek, M. (1998). Ocena konstrukcji zelbetowych po pozarze. XIII Ogolnopolska Konferencja Warsztat Pracy Projektanta Konstrukcji. Ustron.
  • Ogrodnik, P., Zegardlo, B. and Halicka, A. (2012). Wstepna analiza mozliwosci zastosowania odpadow ceramiki sanitarnej w funkcji kruszywa do betonow pracujacych w warunkach wysokich temperatur. Bezpieczenstwo i Technika Pozarnicza, no. 1, pp. 49-56.
  • PN-EN 1992-1-2:2008. (2008). Eurokod 2: Projektowanie konstrukcji z betonu. Czesc 1-2: Reguly ogolne. Projektowanie z uwagi na warunki pozarowe. Warszawa: Polski Komitet Normalizacyjny.
  • Runkiewicz, L., Solonow, W.W. and Kuzniecowa, I.S. (1993). Ocena bezpieczenstwa konstrukcji zelbetowych po pozarze. Inzynieria i Budownictwo, no. 12, pp. 492-495.
  • Sawicz, Z. and Piasta, J. (1981). Zachowanie sie skal i betonow w podwyzszonych temperaturach. In: Proceedings of the XXVII Konferencja Naukowo-Techniczna, Krynica, Poland, 17-22 September 1981.
  • Zegardlo, B. and Ogrodnik, P. (2016). Analiza destrukcyjnego wplywu nasaczenia woda na parametry wytrzymalosciowe betonow poddanych warunkom pozarowym. Bezpieczenstwo i Technika Pozarnicza, vol. 41, no. 1, pp. 27-35.
Uwagi
Opracowanie rekordu w ramach umowy 509/P-DUN/2018 ze środków MNiSW przeznaczonych na działalność upowszechniającą naukę (2018).
Typ dokumentu
Bibliografia
Identyfikator YADDA
bwmeta1.element.baztech-071255be-7d47-44c2-9dbc-26704eccdad4
JavaScript jest wyłączony w Twojej przeglądarce internetowej. Włącz go, a następnie odśwież stronę, aby móc w pełni z niej korzystać.