Interpretation of warpage simulation results in AMSI

• Autorzy: Gajdoš I. , Jachowicz T. , Slota J. , Krasynskyi V
• Języki publikacji: EN

Abstrakty

EN

The article describes the problematic of interpretation of warpage simulation results in Autodesk Simulation Moldflow Insight. Warpage results are relatively easy to obtain from injection molding analysis, but the result interpretation demands higher skilled user. For detailed warpage evaluation based on specific dimensions is application of anchor plane necessary. Theory of anchor plane creation is described and anchor planes were applied for inspection of critical dimension on molding “terminal box”.

Słowa kluczowe

EN

injection molding; warpage; anchor plane

• Wydawca: Polskie Towarzystwo Promocji Wiedzy ; Lublin University of Technology
• Czasopismo: Applied Computer Science
• Rocznik: 2015
• Tom: Vol. 11, no 2
• Strony: 5--16
• Opis fizyczny: Bibliogr. 7 poz., fig.

Twórcy

autor

Gajdoš I.

• Technical University of Košice, Faculty of Mechanical Engineering, Institute of Technologies and Management, Mäsiarska 74 Str., 04001 Košice, Slovakia

autor

Jachowicz T.

• Lublin University of Technology, Faculty of Mechanical Engineering, Department of Polymer Processing, Nadbystrzycka 36 Str., 20618 Lublin, Poland

autor

Slota J.

• Technical University of Košice, Faculty of Mechanical Engineering, Institute of Technologies and Management, Mäsiarska 74 Str., 04001 Košice, Slovakia

autor

Krasynskyi V

• Lviv Polytechnic National University, Department of Chemical Technology of Plastics, S. Bandery 12 Str., 79013 Lviv, Ukraine

Bibliografia

• [1] Taghizadeh S., Özdemir A., Uluer O.: Warpage prediction in plastic injection molded part using artificial neural network, Transactions of Mechanical Engineering, vol. 37, no. M2, pp. 149–160.
• [2] Gajdoš I., [et al.]: Warpage optimization of moldings by DOE. Technological and design aspects of extrusion and injection moulding of thermoplastic polymer composites and nanocomposites, vol. 2, Košice: TU, 2014, pp. 37–52. – ISBN 978-80-553-1677.
• [3] Gajdoš I., Slota J.: Počítačová simulácia vstrekovania plastov – Návody na cvičenia. Vol. 1, Košice: TU, 2014, p. 108. – ISBN 978-80-553-1647.
• [4] Help for software Autodesk Simulation Moldflow Insight 2013.
• [5] Janecki D., Stępień K., Adamczak S.: Problems of measurement of barrel – and saddle-shaped elements using the radial method, Measurement. Vol. 43, no. 5, 2010, pp. 659–663.
• [6] Tor-Swiatek A., Sikora J.W.: Effect of poly(vinyl chloride) modification with microspheres on geometric structure of extrudates. Przemysl Chemiczny, vol. 92, issue 4, 2013, pp. 53–541.
• [7] Jachowicz T., Moravskyi V., Gajdoš I.: Numerical modeling of cooling conditions of thermoplastic injection-molded part. Technological and design aspects of extrusion and injection moulding of thermoplastic polymer composites and nano-composites, vol. 3, Monograph – Lublin: Lublin University of Technology, 2015, pp. 31–49. – ISBN 978-83-89263-37-7.