Preferencje help
Widoczny [Schowaj] Abstrakt
Liczba wyników
2007 | 5 | 4 | 931-950
Tytuł artykułu

Characterization of the passive films on electrodeposited Fe-Ni-Cr alloys in borate solution at pH 8.4

Treść / Zawartość
Warianty tytułu
Języki publikacji
The corrosion properties of the passive layers formed on iron-nickel-chromium electrodeposits of Fe29Ni51Cr20 were investigated in 0.3 M borate solution at a‘ pH of 8.4. On the basis of measurements by cyclic voltammetry, chronopotentiometry and electrochemical impedance spectroscopy, a low passive dissolution/corrosion rate was identified for the electrodeposited Fe-Ni-Cr alloys due to the nature of the established corrosion layer. The stability of this passive layer was further enhanced after corrosion under oxidizing conditions. Mössbauer spectroscopic measurements confirmed the existence of a thin passive layer on the amorphous electrodeposits. [...]

Opis fizyczny
  • Hungarian Academy of Sciences, Eötvös Loránd University, 1518 Budapest, P.O.B. 32, Hungary,
  • Glasgow Caledonian University Glasgow G4 0BA, Scotland, United Kingdom
  • Department of Physical Chemistry of Eötvös Loránd University, Hungary
  • Institute of Isotopes, Hungarian Academy of Sciences, Budapest, Hungary
  • [1] J.R. Thompson, A. Goyal, D.K. Christen and D.M. Kroeger: “Ni-Cr textured substrates with reduced ferromagnetism for coated conductor application”, Physica C, Vol. 370, (2002), pp. 169–176.[Crossref]
  • [2] A. Vértes, L. Korecz and K. Burger: Mössbauer Spectroscopy, Elsevier, Amsterdam, 1979.
  • [3] E. Kuzmann, S. Stichleutner, M. El-Sharif, C.U. Chisholm, L. Sziráki and A. Vértes: “Mössbauer Investigation of Electrodeposited Sn-Zn, Sn-Cr, Sn-Cr-Zn and Fe-Ni-Cr Coating”, Hyp. Int., Vol. 141, (2002), pp. 425–433.[Crossref]
  • [4] E. Kuzmann, M. El-Sharif, C.U. Chisholm, G. Principi, C. Tosello, A. Gupta, K. Havancsák, L. Takács and A. Vértes: “Mössbauer Studies of Electrodeposited and Ion Beam Mixed Alloy Coating”, Hyp. Int., Vol. 139-140, (2002), pp. 193–204.[Crossref]
  • [5] M.R. El-Sharif, A. Watson and C.U. Chisholm: “The sustained deposition of thick coatings of chromium/nickel and chromium/nickel/iron alloys and their properties”, Trans IMF, Vol. 66, (1988), p. 34.
  • [6] E. Kuzmann, M.R. El-Sharif, C.U. Chisholm and A. Vértes: “Conversion electron Mössbauer study of short range ordering in electrochemically deposited Fe-Ni-Cr alloy”, J. Radioanal. and Nucl. Chem., Vol. 190, (1995), pp. 327–332.[Crossref]
  • [7] L. Sziráki, E. Kuzmann, M.R. EL-Sharif, C.U. Chisholm, G. Principi, C. Tosello and A. Vértes: “Electrochemical behaviour of electrodeposited strongly disordered Fe-Ni-Cr alloy”, Electrochem. Commun., Vol. 2, (2000), pp. 619–625.[Crossref]
  • [8] U. Erb, K.T. Aust and G. Palumbo: “Electrodeposited nanocrystalline materials”, In: C.C. Koch (Ed.): NanoStruct Mater., Noyes publications/W. Andrew Publ., Norwich, 2002, Ch. 5.
  • [9] M.I. Kjuchukova, S.D. Vitkova, O.L. Blagiev, V.V. Ivanova and G.M. Raichevski: “X-ray photoelectron spectroscopic studies of the anodic behaviour of amorphous chromium-carbon and crystalline chromium electrodeposits”, Bulgarian Chem. Commun., Vol. 31, (1999), pp. 25–37.
  • [10] U. Erb: “Electrodeposited nanocrystals: synthesis, properties and industrial application”, NanoStruct. Mater., Vol. 6, (1995), pp. 533–438.[Crossref]
  • [11] B. Inturik and Z. Szklarska-Smialowska: “Localised corrosion of nanocrystalline 304 type stainless steel films”, Corrosion, Vol. 48, (1992), pp. 398–400.
  • [12] L. Kwiatkowski and F. Mansfeld: “Surface modification of stainless steel by an alternating voltage process”, J. Electrochem Soc., Vol. 140, (1993), pp. L39–L41.[Crossref]
  • [13] S. Fujimoto, K. Tsujino K. Wada and T. Tsutae: “Electrochemical conditions for coloured film formation on type 304 stainless steel with square wave polarization”, Corros. Sci., Vol. 35, (1993), pp. 147–152.[Crossref]
  • [14] S. Fujimoto, K. Tsujino and T. Shibata: “Growth and properties of Cr-rich thick and porous oxide films on Type 304 stainless steel formed by square wave potential pulse polarisation”, Electrochim. Acta, Vol. 47, (2001), pp. 543–551.[Crossref]
  • [15] M. Vukovic: “Formation and growth of hydrous oxide film on stainless steel in alkaline solution by potential cycling”, Corros. Sci., Vol. 37, (1995), pp. 111–120.[Crossref]
  • [16] Z. Klencsár, E. Kuzmann and A. Vértes: “User-friendly software for Mössbauer spectrum analysis”, J. Radioanal. Nucl. Chem., Vol. 210, (1996), pp. 105–118.[Crossref]
  • [17] E. Murad and J.H. Johnston: “Iron Oxides and Oxyhydroxides”, In: G.J. Long (Ed.): Mössbauer Spectroscopy Applied to Inorganic Chemistry, Vol. 2, Plenum Press, New York, 1987, p. 533.
  • [18] A. Vértes, Gy. Vankó, Z. Németh, Z. Klencsár, E. Kuzmann, Z. Homonnay, F.H. Kármán, E. Szücs and E. Kálmán: “Nanostructure of vapor-deposited 57Fe thin films”, Langmuir, Vol. 18, (2002), pp. 1206–1210.[Crossref]
  • [19] M.J. Carmezin, A.M. Simões, M.F. Montemor and M. Da Cunha Belo: “Capacitance behaviour of passive films on ferritic and austenitic stainless steel”, Corr. Sci., Vol. 47, (2005), pp. 581–591.[Crossref]
  • [20] N. Sato and G. Okamoto: “Passivity of metals”, In: J. O'Bockris (Ed.): Comprehensive Treatise of Electrochemistry, Vol. 4, Plenum Press, NY, 1981, Ch. 4.
  • [21] D.C. Agarwal: “Nickel and nickel alloys”, In: R.W. Revie (Ed): Uhlig's Corrosion Handbook, J. Wiley & Sons, Inc., New York, 2000, Ch. 45.
  • [22] J.A. Bardwell, G.I. Sproule, D.F. Mitchell, B. Macdougall and J. Graham: “Nature of the passive film on Fe-Cr alloys as studied by 18O secondary mass spectrometry: reduction of the prior film and stability to ex-situ surface analysis”, J. Chem. Soc. Faraday Trans., Vol. 87, (1991), pp. 1011–1019.[Crossref]
  • [23] Z. Stoynov and D. Vladikova: Differential Impedance Analysis, M. Drinov Akad. Publ. H., Sofia, 2005, p. 46.
  • [24] D.D. Macdonald: “Point defect model for the passive state”, J. Electrochem. Soc., Vol. 139, (1992), pp. 3434–3449.[Crossref]
  • [25] D.D. Macdonald: “Passivity-the key is our metals-based civilization”, Pure Appl. Chem., Vol. 71, (1999), pp. 951–978.[Crossref]
  • [26] M. Bojinov, G. Fabricius, T. Laitinen, K. Mäkelä, T. Saario and G. Sundholm: “Coupling between ionic defect structure and electronic conduction in passive films on iron, chromium and iron-chromium alloys”, Electrochim. Acta, Vol. 45, (2000), pp. 2029–2048.[Crossref]
  • [27] M. Bojinov, G. Fabricius, P. Kinnunen, T. Laitinen, K. Mäkelä, T. Saario and G. Sundholm: “Electrochemical Study of the passive behaviour of Ni-Cr alloys in a borate solution-a mixed-conduction model approach”, J. Electroanal. Chem., Vol. 504, (2001), pp. 29–44.[Crossref]
  • [28] C.R. Clayton and I. Olefjord: “Passivity of austenitic stainless steels”, In: P. Marcus and J. Oudar (Eds.): Corrosion mechanism in theory and practice, Marcel Dekker, NY, 1995, Ch. 6.
  • [29] G. Goodlet, S. Faty, S. Cardoso, P.P. Freitas, A.M. Simões, M.G.S. Ferreira and M. Da Cunha Belo: “The electronic properties of sputtered chromium and iron oxide films”, Corr. Sci., Vol. 46, (2004), pp. 1479–1499.[Crossref]
  • [30] S.R. Morrison: Electrochemistry at semiconductor and oxidized metal electrodes, Plenum Press, NY, 1980, Ch. 5.
  • [31] F.A. Kröger: The Chemistry of Imperfect Crystals, Vol. 2, North-Holland Publishing, Amsterdam, 1974, p. 31, 744.
  • [32] I.D. Raistrick, D.R. Franceschetti and J.R. MacDonald: “Theory”, In: J. Barsoukov and J.R. MacDonald (Eds): Impedance spectroscopy: Theory, experiments, and applications, Wiley-Interscience, N.J., 2005, Ch. 2.
  • [33] C.A. Schiller and W. Strunz: “The evaluation of experimental dielectric data of barrier coatings by means of different models”, Electrochim. Acta, Vol. 46, (2001), pp. 3619–3625.[Crossref]
  • [34] C.H. Hsu and F. Mansfeld: “Concerning the conversion of the constant phase element parameter Y 0 into a capacitance”, Corrosion, Vol. 57, (2001), pp. 747–748.[Crossref]
  • [35] N.V. Myunk and K. Nobe: “Electrodeposited Iron Group Thin-Film Alloys: Structure-Property Relationships”, J. Electrochem. Soc., Vol. 148, (2001), pp. C136–C144.[Crossref]
  • [36] Sh. Deng and Z. Gong: “The electrochemical behaviour of pulse-plated nanocrystalline iron-nickel-chromium alloy”, Anti-Corrosion Methods and Materials, Vol. 50, (2003), pp. 267–270.[Crossref]
Typ dokumentu
Identyfikator YADDA
JavaScript jest wyłączony w Twojej przeglądarce internetowej. Włącz go, a następnie odśwież stronę, aby móc w pełni z niej korzystać.